but i also outlined some steps and info as follows
Skull molds - https://amzn.to/3Sn1vdx
Ring Holder Molds (cone) - https://amzn.to/3FKHl5G
Ring Holder Molds (small) https://amzn.to/45Zo235
Ring Molds - https://amzn.to/3sgALRl
Phone Stand Molds ,Pictures Frame, Foldable Photo Frame, Mold - https://amzn.to/3Sshozl
Crystal Cluster Molds - https://amzn.to/3Qqve2p
*Note* i would never use my oven i use to cook food in. in fact i think a toaster oven is the best idea in a well vented area. iv done this outside on my deck. and in my basement (window exhust fan running) , and you will still smell melting plastic slightly . its not bad.
but do yourself a favor and be in as much open air as possible.
I picked up my toaster oven used for $20 via facebook market place.
but amazon has good deals too. also im going to invest in some Oven Gloves as well! -https://amzn.to/3MReUXR
- bake at 200c /400F sometimes i use small bits.
sometimes i toss in full benchy prints .
Iv never used a blender. smaller parts will melt down faster but its not worth the effort for me to blend everything.
Then wait till it melts down even about 10 -15mins depending on the size of plastic added
Then add more plastic as needed
then wait ....
then add more...
then wait...
and so on till its full and melted
then remove from oven,
let cool for 20 mins
enjoy plastic fully molded
$40 toaster oven - https://amzn.to/3Qnl9Dp
$170 toaster oven - https://amzn.to/40oGFfK
Oven Gloves 932°F Heat Resistant Gloves - https://amzn.to/3MReUXR
